How to control 360 Continuous Servo with Arduino
How to control 360 Continuous Servo with Arduino
this video will show you how to change the direction of rotation of continuous 360 servo motor using Arduino and how to stop it.
Get the code for this video: http://robojax.com/learn/arduino/?vid=robojax-servo-360
Control 360 Servo with push buttons:
https://youtu.be/hVe4TSRV4ww
Get Early access to my vidoes via Patreon http://bit.ly/2ZnITLz
My Arduino Course on Udemy: http://bit.ly/rj-udemy
Tutorial by Robojax.com
Get other projects code and learn Arduino
http://robojax.com/learn/arduino
20190318-AD
How to control 360 Continuous Servo with Arduino
How to control 360 Continuous Servo with Arduino
Related Posts
About The Author
Arianto
17 Comments
That's great project. How to control speed of 360 rotation. Thanks.
Nice one again
This motar Voltage A/c. Dc
well, done, bravo, brao bravo…just DON'T STOP NOW !!!
Hi, what's model of servo did you use in this video? great job!
hello, im having problems with the Serial.read process, for some reason when i insert a value, a few seconds later the value turns to 0 which is NULL, which automatically switches the orientation of spin. please help
Hey there. How do you get that command line manager window to open up? The window where you are changing the speed values? Please advise! Nixe video!
Hi, great video
For what purpose do we use 360 servo? Can these be used in place of normal servo (i.e. those rotating 180 deg)? If yes,how?
I am not able to control 360 degree servo , whenever I am sending any command like r or l …it would not work accordingly
If you try to move the servo arm while it is stopped (not powered off/unplugged), will it move because it is a continuous rotation servo? I know with regular servos that have position control, you cannot move the servo arm when it is stopped because it stays at that position, but do continuous rotation servos do the same thing?
How can I make it into 2 servos
how can we center this servo?
hey!! It's a great project. But i am facing some problems. After typing the character the serial monitor shows the corresponding dec but after each line there's a line saying" received: 10 moving Random" and there is no change in the rotation of the motor.. Please help me here!!
the position it stops is the center? right?
I try coding servo which rotation degree is 0 and 90 ….. how can it run continously in range of 300ms???… .. I try using delay() … but the servo disconnect as it reads the delay function
Hello we are trying to make a solar tracker project. We found codes from internet and they used sg90 (180°) but I have mg996 (360°)
It doesn't work properly
What should we change to work it with mg996?
Thank you, very helpful….