Instrumentation and Control Training- Control Valve Positioner Calibration

Instrumentation and Control Training- Control Valve Positioner Calibration

POSITIONER CALIBRATION
CALIBRATION.
The goal of calibration, or alignment, is to ensure that the positioner is functioning correctly with in design tolerances.
The basic calibration process consists of three steps:
I. Bench set confirmation
II. Feedback linkage alignment, including cam alignment
III. Zero and span adjustment
IV. Inline or Online Calibration.

ABOUT THIS CHANNEL
INSTRUMENTATION AND CONTROL STUDENTS, Freshers & Beginning Stage Technicians will get more knowledge from here about instrumentation field in OIL &GAS, REFINERIES, PETROCHEMICAL, POWER PLANT etc.

Field Instruments like transmitter, control valve, Solenoid valve, PRV, PSV, MOV, ESDV service and calibration

Plant equipments like instrument air compressor, gas turbine, steam boiler, crude oil separator, deasalter, oil bath heater,heat exchanger,
different types of pumps shutdown protection system and start up procedures.

Instrumentation interview question and answers, process control instrumentation training, Instrumentation and control training for freshers and students

Here Available all basics of instrumentation notes, and how to attend interviews for abroad jobs and whats are the questions will be asked in interview sessions,

SUBSCRIBE this channel, we will discuss more and travel together…

Contact
E-mail : karthikeyaninst@gmail.com
Instrumentation and Control Training- Control Valve Positioner Calibration



Instrumentation and Control Training- Control Valve Positioner Calibration

2 Comments

Add a Comment

Alamat email Anda tidak akan dipublikasikan. Ruas yang wajib ditandai *