SAMSON 3730-3 Positioner Calibration
|SAMSON 3730-3 Positioner Calibration
In this short how-to video, we’ll illustrate how to reset a 3730-3 Positioner to factory default settings and perform an auto calibration. For this example, we’ve mounted the positioner to a 2″ 3241 valve and a 3277 (350cm) actuator.
Detailed step-by-step instructions can also be found by following the link below.
http://www.samsoncontrols.com/how-to-video/3730-3-positioner-calibration240-350cm-fail-close
SAMSON 3730-3 Positioner Calibration
SAMSON 3730-3 Positioner Calibration
8 Comments
good lesson
hi, excellent the explanation but I have one doubt, as is the air connection to the valve positioner. installation of tubing?
samson acquired a valve but do not understand how to connect, the manuals do not contain too much information about it, I have a pressure regulator 4708.
As someone familiar with the 3730-3 positioner this video might score a 5 out of 10. To many critical brief explanations are left out such as how to determine the pin position (code 4), or the fail position (code 7). Even if you follow the link to the detailed step by step instructions you don't get this information. Samson makes good instruments but do a very poor job of marketing and supporting them at least in the United States.
when reset to defaults is done .communication to the positioner is lost or not.
when done some codes disappeared such as op code no. 44
how to solve this problem please
good info.. thanks.. pls tell how to troubleshoot if feedback not show in hmi
I got help from this. Thanks.
excelente enseñanza gracias alas personas q hacen realidad está capacitación.
Samsung positioner calibration ka video Hindi Mein Band Ho sar very nice video