Mitsubishi GX Developer Training PT 1
|Mitsubishi GX Developer Training PT 1
How to start programming in ladder logic using the Mitsubishi GX developer. This part shows how to create a new project.
http://www.icontrol.co.nr
Mitsubishi GX Developer Training PT 1
Mitsubishi GX Developer Training PT 1
8 Comments
Where can I find the "R" Registers?
Thank you very much for the yours tutorials , i really appreciate them!!!
but in my software there is no any option of new project
Can you tell me how to do analog input programming?
Hi Robert
Just wondering if you could help me with something
I am trying to change the setpoints on a PT100 that i have in a tank that is controlling a process. I am using GX works software and the temperature control module is an FX3U 4AD. The thing is i am a novice at this and i am not sure how to navigate through the software to find this or how to begin. The PT100 is using 3 setpoints to heat and cool a process 110 degrees c then 100 and then to 80 i just want to change the 110 to 100 but i am not sure how to go about this. Also this PLC is connected to a HMI display. I know this may sound silly but i was expecting to see the values somewhere in the program ie. 110c 100c 80c. but all i see are the M8000 etc and dont know how they relate to the setpoints
Please put a link of this program
I tried to connect to a FX-48MR PLC for more than an hour last night with no success. Can someone tell me where the "FX" option is in PLC TYPE? All I see there is FX0 to FX3 and variations within. There is no straight up "FX" type in my version of GX Developer. Also, I found some evidence that the serial connection might be RS-422. Is this true? I was attempting RS-232.
Hi, I have uploaded program from FX series by old GX developer now How to find address of analog input configured in PLC.